Rapid Detection of Yersinia pestis by Real-time Recombinaseaided Amplification＊

WEI Xiao, LI Yan, LU Xin, ZHAO Rong Tao, YUAN Zheng Quan,SHI Hua,#, and ZHAO Xiang Na,#

Yersinia pestis, the causative agent of bubonic and pneumonic plague, is considered to be one of the most dangerous and deadly pathogenic bacteria in the world[1].Y. pestisis classified as a category A pathogen by the United States Center for Disease Control and Prevention because of its ease of aerosol-to-human transmission, high lethality, and potential for mass casualties as a biological warfare agent[2]. Therefore, both prevention and treatment require the development of a rapid, sensitive, and specific method to detectY. pestis.

Traditional methods for the detection ofY. pestismainly include bacterial isolation and microscopic observation, enzyme-linked immunosorbent assay(ELISA) based on antibody-mediatedidentification of the F1 antigen, conventional polymerase chain reaction (PCR) detection, a phage lysis test, and optical fibers or an up-conversion fluorescence biosensor[3]. The fiber optic biosensor uses the purified antibody against antigen FI immobilized on polystyrene probes as the capture antibody and the monoclonal antibody-Cy5 conjugate as the detector[4]. The up-conversion fluorescence biosensor uses 400 nm up-converting phosphor particles as the reporter[5]. These methods play a significant role in the detection ofY. pestis.However, each technique has its own shortcomings,such as assay time, and the need for costly equipment and highly skilled personnel. Over the past few decades, several non-PCR isothermal amplification techniques have been developed,based on the molecular biology of DNA/RNA synthesis. These techniques do not require the use of thermal cyclers, making it easy to detect nucleic acids at a constant temperature. Two of the most successful methods areloop-mediated isothermal amplification (LAMP) technology and recombinase polymerase amplification (RPA). Feng et al.[6]took advantage of LAMP to detectY. pestis, which would be an ideal assay if this technology were inexpensive and not time-consuming. Euler et al.[7]achieved good results using RPA to detectY. pestis, but the plasmidharboredplagene is less labile. The target genes on chromosome might be more stable. In thisstudy, we constructed a real time recombinase-aided amplification (rt-RAA) method to detectY. pestisbased on the 3a sequence on chromosome, which might recognize a greater amount of samples.Consequently, a simple, rapid, and effective diagnostic method is still urgently needed for longterm surveillance of plague foci in poverty-stricken areas to predict future rodent-borne epidemics and human exposure risks, or for on-site investigation of suspected bioterrorism samples.

Recombinase-aided amplification (RAA) is a new isothermal amplification technology that is receiving much attention for its efficient amplification of DNA with high specificity and sensitivity under isothermal conditions of 39 °C–42 °C in less than 30 minutes[8].rt-RAA uses the fluorescence signal collected during the amplification process to achieve real-time detection. This method only requires a simple water bath or similar stable heating method, making it suitable for field applications, especially in poor regions. In addition, many scholars have achieved satisfactory results using this technique to detect pathogens[8,9].

In this study, we aimed to develop an rt-RAA assay for the detection ofY. pestis. We evaluated the analytical sensitivity and specificity of the rt-RAA assay, and tested whether it could be used to detectY. pestisin simulated tissue samples.

Table 1. Bacterial strains used in this study

The strains used for specificity test in this study were shown in Table 1. The 3a genetic sequence is commonly chosen as the target region for the detection ofY. pestis[10]. All of the 3a sequences available forY. pestiswere obtained from the National Center for Biotechnology Information(NCBI) database. The Oligo7 software was used to design the primers and probes (Table 2). Each rt-RAA reaction contained the following components in the reaction mixture: 1 μL DNA template, 25 μL rehydration buffer, 16.7 μL ddH2O, 2.1 μL primers(10 μmol/L), and 0.6 μL target-specific rt-RAA exoprobe (10 μmol/L). Finally, the 47.5 μL mixture/template solution was transferred to each lyophilized rt-RAA particle provided in the kit. In each reaction, 2.5 μL of 280 mmol/L magnesium acetate was dripped into the cap of the tube. The cap of the tube was carefully closed, the contents were mixed gently by swirling, followed by brief centrifugation. The magnesium acetate dripped into the reaction mixture during centrifugation, initiating the rt-RAA reaction. Then, rt-RAA fluorescence detection device rt-RAA-F1620 (Jiangsu Qitian Bio-Tech Co. Ltd., China) transferred the test tube to the test tube rack for 20 min of amplification.Y. pestisDNA and ddH2O were included as positive and negative controls, respectively. Conventional rt-PCR was performed according to the protocols of the Superreal premix Plus (SYBR green) FP205 (Tiangen Biochemical Technology Co. Ltd., China) in the rt-PCR fluorescence detection device CFX96 Real-Time system (Bio-Rad, USA).

To determine the sensitivity of the rt-RAA assay for the detection ofY. pestisEV76, we used sequential 10-fold dilutions of bacterial genomic DNA as a template for rt-RAA fluorescence detection. The results showed that all the dilutions of bacterial genomic DNA, from 1.74 × 105to 1.74 ×101copies per reaction, produced apositive result in the assays. Two of the nine replicates with 1.74 copies per reaction tested positive in the rt-RAA assay. Statistical analyses indicated that the detection limits of the rt-RAA assay were thus 17.4 copies per reaction forY. pestisDNA (binomial distribution,P= 0.04 < 0.05). In addition, rt-RAA was able to detect a change in fluorescence signal at 2–4 min, with a final result available after 20 min.

To determine the specificity of rt-RAA detection forY. pestis, we extracted 30 bacterial genomic DNAs extracted from pure culture and applied them as templates at 1 × 103copies of DNA per reaction for rt-RAA and real-time quantitative PCR (rt-qPCR)fluorescence detection. Fluorescence signals were only detected in the reactions containingY. pestisEV76 andY. pestis201 DNA, whereas no fluorescence signal was detected for any of the other bacterial DNA samples (Figure 1). Kappa test results(к = 1.0,P< 0.01) indicated that the rt-RAA and rt-PCR assays both demonstrate good consistency in the detection ofY. pestis.

To verify the feasibility of the rt-RAA assay for the detection of biological samples, we artificially contaminated mouse blood with different concentrations of bacteria and then extracted DNA from the mixed sample for analysis by rt-RAA. No fluorescent signal was detected in the negative control or PBS groups, but a fluorescent signal was detected in the samples contaminated withY. pestisEV76. As the bacterial concentration increased in the biological samples, a concomitant increase in the fluorescence signal was detected, confirming that the rt-RAA assay can effectively detectY. pestisin blood. We also used this method to test contaminated liver, lung, and spleen samples, and the results demonstrated that rt-RAA can be used to detectY. pestisin a range of biological samples.

Table 2. Primer and probe sequences used for RT-RAA and RT-PCR assays

The3agene, located in a 41.7-kbY. pestisspecific region, has been used as a target gene in previous studies for the detection ofY. pestis[10].Amplification using a primer pair designed to the3agene sequence has been used to identify isolates ofY. pestiswithout producing false positives for closely related organisms, which is an important criterion for unambiguous bacterial identification[10]. In this study, we selected the3agene as a target sequence and established a new constant-temperature realtime fluorescence detection assay for the rapid detection ofY. pestis. This alternative chromosomal target (3agene) is present at a lower copy number but has the advantage of being less labile, unlike the plasmid–harbored genechosen by Euler et al.[7]. Our assay had a detection limit of 17.4 gene copies per reaction. Yan et al.[11]and Chen et al.[8]employed RAA to detect coxsackievirus A6 and respiratory syncytial virus (RSV), respectively, and demonstrated that RAA could be used to quantitatively amplify the virus genome in real-time[9]. Our study drew similar conclusions, confirming that RAA could effectively and specifically detectY. pestiswith the same specificity as rt-qPCR. In addition to the faster processing time, the requirement for a constant temperature of 39 °C is another advantage of rt-RAA over rt-PCR, which normally requires a range ofcycling temperatures performed under rigorous conditions. The rt-RAA detection system does not require a sophisticated laboratory setting or expensive equipment, and can be performed using a portable device. Furthermore, the results can be obtained by recording fluorescence without opening the sample tubes, which minimizes concern regarding contamination ofthe amplified products.Despite its high sensitivity and specificity, the expensive instrumentation and need for skilled operators restricts the wide clinical application of rtqPCR, whereas RAA has the potential for rapid detection ofY. pestisin the field.

To verify that rt-RAA can be accurately and reliably applied forbiological sample detection, we tested the assay on mouse tissue samples. We selected the blood, liver, spleen, and lung tissues of mice for monitoring. It has been reported that the bacterial load of liver and lung can reach 1 × 104and 1 × 106CFU/g after 4 h of infection, and that of blood and spleen can reach 1 × 103CFU/g after 36 h[12]. The rt-RAA assay was sensitive enough to detect the tissues which were blended with the 1 × 103CFU bacterial suspension.These results showed that RAA technology can rapidly detect pathogens and the sensitivity of this technique shouldbe sufficient for clinical testing needs.

Figure 1. The specificity (A, B) of rt-RAA and rt-qPCR assays for the detection of Y. pestis using 30 bacterial genomic DNAs. (A) rt-RAA assay results. (B) rt-qPCR assay results.

In conclusion, the rt-RAA assay described here is a sensitive and specific method for the rapid detection ofY. pestis. However, use of the RAA assay still has some limitations to overcome. For example,nucleic acid extraction must be performed before sample detection, and the premixing step is indispensable. Both of these processing steps can affect the results[11]. Optimizing the assay to overcome these shortcomings will be the focus of future studies.

The authors declare no competing financial interests.

WEI Xiao, LI Yan, and LU Xin performed the experiments and contributed equally to this study as joint first authors. ZHAO Rong Tao and YUAN Zheng Quan provided the bacterial strains. SHI Hua and ZHAO Xiang Na wrote the article.

&These authors contributed equally to this work.

#Correspondence should be addressed to SHI Hua,Tel: 86-10-66948393, Fax: 86-10-66948304, E-mail: placdc@139.com; ZHAO Xiang Na, Tel: 86-10-66948393, Fax: 86-10-66948304, E-mail: xnazhao@163.com

Biographical notes of the first authors: WEI Xiao,female, born in 1986, Doctor’s Degree, Associate Professor, majoring in the genomics and metabolomics of pathogenic microorganisms; LI Yan, female, born in 1985,Master’s Degree, majoring in pest control operation; LU Xin, female, born in 1986, Bachelor's Degree, Supervisor nurse, majoring in general surgical nursing work.

Received: June 11, 2020;

Accepted: August 31, 2020